Contactor DILM 15-01 (230V.50Hz;240V.60Hz) EATON

Description Contactor DILM 15-01 (230V.50Hz;240V.60Hz) EATON

Virobnik: EATON
Contactor type: DILM15-01
Nominal voltage of the heating coil (50 Hz): 230 V AC
Nominal voltage of the AC coil (60 Hz): 240 V AC
Head strength poles: 3
Number of auxiliary contacts (normally closed): 1 NC
Stocking categories: AC-1, AC-3
Nominal operating voltage Ue: 690 V exchanger
Nominal insulation voltage Ui: 690 V
Nominal impulse voltage Uimp: 8 kV
Thermal flow Ith (AC-1, <=55°C): 32 A
Nominal operating flow Ie (AC-1, 690 V): 32 A
Nominal operating flow Ie (AC-3, 220-230 V): 17 A
Nominal operating voltage Ie (AC-3, 380-400 V): 15 A
Nominal operating voltage Ie (AC-3, 660-690 V): 10 A
Nominal operating voltage P (AC-3, 220-230 V): 4 kW
Nominal operating voltage P (AC-3, 380-400 V): 7.5 kW
Nominal operating voltage P (AC-3, 660-690 V): 7.5 kW
Maximum short-hour vitrification Icw (1 s): 225 A
Increased coil tension (retracted, 50 Hz): 69 VA
Reduced coil pressure (retracted, 60 Hz): 63 VA
Amplified coil tension (morning, 50 Hz): 7.9 VA
Reduced coil tension (morning, 60 Hz): 7.3 VA
Spray range of the coil (pull): 0.8 - 1.1 x Us
Spray range of the coil (pull): 0.3 - 0.6 x Us
Nominal operating current of auxiliary contacts Ie (AC-15, 220-240 V): 6 A
Nominal operating current of auxiliary contacts Ie (AC-15, 380-440 V): 3 A
Nominal operating current of auxiliary contacts Ie (DC-13, 220 V): 0.3 A
Mechanical wear resistance: 10 x 10^6 cycles
Electrical wear resistance (AC-3): 1.5 x 10^6 cycles
Operating temperature range: -25 to +60 °C
Saving temperature range: -40 to +80 °C
Protection level: IP20
Altitude above the sea level (without derating): up to 2000 m
Type of head terminals: Screw terminals
Type of head terminals: Screw terminals
Cutting of the head conductor (hard, min.): 1 mm²
Cutting of the head conductor lance (hard, max.): 6 mm²
Circle of the conductor of the head lance (bend with tip, min.): 0.75 mm²
Cut of the conductor of the head lance (bend with tip, max.): 6 mm²
Tightening torque (head terminals): 2 Nm
Circulation of the conductor lancet ceruvian (hard, min.): 1 mm²
Ceresis of the conductor lancjug ceruvanny (hard, max.): 2.5 mm²
Ceresis of the conductor lancet ceruvian (hard) with tip, min.): 0.75 mm²
Ceramic conductor cross-section (bend with tip, max.): 2.5 mm²
Tightening torque (additional/ceramic terminals): 1.2 Nm
Width: 45 mm
Height: 75 mm
Depth: 106 mm
Wague: 0.36 kg
Mounting type: DIN rail 35 mm
Mounting type (add-on): Screw