Contactor DILM 15-10 230V 50Hz EATON

Description Contactor DILM 15-10 230V 50Hz EATON

Nominal power supply AC-3 at 400V: 15 A
Nominal operating power AC-3 at 220-230V: 4 kW
Nominal operating power AC-3 at 380-400V: 7.5 kW
Nominal operating power AC-3 at 660-690V: 7.5 kW
Nominal power supply AC-1 at 690V: 32 A
Number of head normally open (NO) contacts: 3
Number of head normally closed (NC) contacts: 0
Quantity additional normally open (NO) contacts: 1
Number of additional normally closed (NC) contacts: 0
Nominal voltage of the coil: 230 V AC
Coil frequency: 50 Hz
Coil type: Serpentine Strum (AC)
Increased tension of the coil when retracted: 65 VA
Reduced tension of the cat when morning: 7 VA
Rated operating voltage Ue: up to 690 V AC
Nominal impulse voltage Uimp: 6 kV
Drying category: AC-1, AC-3, AC-4
Electrical wear resistance AC-3: 1.5 million cycles
Mechanical wear resistance: 10 million cycles
Protection level: IP20
Temperature of the superfluous core (working): -25...+60 °C
Temperature of the superfluous middle (zberіgannya): -40...+80 °C
Width: 45 mm
Height: 75 mm
Glibina: 106 mm
Vaga: 0.35 kg
Type of head terminals: screw Clemie
Head contact conductor strut (flexible, with ferrule): 1-6 mm²
Head contact conductor crossbar (hard): 1-10 mm²
Type of terminals for auxiliary/fuel contacts: Screw terminals
Crossbar of auxiliary/core contact conductor (flexible, with tip): 0.75-2.5 mm²
Crossbar of auxiliary/core contact conductor (hard): 0.75-4 mm²
Installation method: On a 35 mm DIN rail or with screws
Compliance with standards: IEC/EN 60947-4-1, IEC/EN 60947-5-1, VDE 0660