Automatic Transfer Switch (ATS) with motor drive, controller/metering/communications, I-0-II, 4-pole 1000A, HIC490E

Description Automatic Transfer Switch (ATS) with motor drive, controller/metering/communications, I-0-II, 4-pole 1000A, HIC490E

Nominal flow: 1000 A
Number of poles: 4
Intermittent mode: I-0-II
Drive type: Motorized
Type of transfer pump: Automatic transfer to reserve (AVR)
Case type: Case
Nominal operating voltage (Ue): 400 V AC
Nominal insulation voltage (Ui): 1000 V AC
Nominal impulse voltage (Uimp): 8 kV
Nominal frequency: 50/60 Hz
Vikoristan category: AC-33B
Nominal short-circuit current (Icw): 50 kA / 1 s
Nominal peak vitrification flow (Icm): 110 kA
Mechanical wear resistance: 5000 cycles
Electrical wear resistance: 1500 cycles
Humbling hour: <3 s
Power supply voltage for motor drive: 230 V AC
Controller functions: Automatic switching, Manual switching, Monitoring of voltage parameters, Low phase protection, Voltage under/overvoltage protection, Protection against frequency under/overfrequency, Protection against phase imbalance
Display: LCD
Variable parameters: Voltage (phase/linear), Stream (by phases), Frequency, Active tension, Reactive tension, Extended tension, Tension coefficient, Energy (active/reactive)
Communication interface: RS485
Communication protocol: Modbus RTU
Inputs/Outputs: Programmable digital inputs, Programmable relay outputs
Housing protection level: IP54
Temperature operation: -20°C to +70°C
Storage temperature: -40°C to +85°C
Water content: 5% to 95% (non-condensing)
Height above the sea level: up to 2000 m
Installation method: Underground / wall
Compliance with standards: IEC 60947-6-1