Industrial (construction) hair dryer 2 kW WOKIN WK-785021

Description Industrial (construction) hair dryer 2 kW WOKIN WK-785021

Powerful hair dryer for construction work with two temperature modes - from 350°C to 500°C. Equipped with a fan motor that delivers up to 500 liters of air per minute and is approved according to the international CE standard. An indispensable assistant when soldering plastic, thawing frozen materials, and heat treating materials on a construction site.

Key advantages

Two power modes

In the first mode, the hair dryer delivers 1000 watts at 350°C with a flow rate of 300 l/min, in the second - a full 2000 watts at 500°C with a flow rate of 500 l/min. You select the power for a specific job.

Set of nozzles included

Four nozzles for different tasks: pointed for precise work, reversible for difficult angles, wide-angle for large areas and with edge protection for working close to sensitive materials.

Hot flow without problems

Power supply from the mains 230-240 V, frequency 50 Hz. The design is engineered for long-term operation without overheating thanks to high-quality ventilation.

Package and packaging

Industrial hair dryer 2 kW with four nozzles: pointed, reversible, wide-angle and with edge protection. Packed in a color box, ready for immediate use after unpacking.

At what temperature should you use when removing insulation or soldering? It depends on the material. For most synthetic materials and adhesives, the first mode at 350°C with a flow rate of 300 l/min is sufficient. If it does not work, switch to the second mode at 500°C. Always start with a lower temperature and gradually increase it to avoid damaging the workpiece.

What is the continuous operating time of this hair dryer? The hair dryer is designed for long-term use. However, it is recommended to take short breaks every 20-30 minutes during work to prevent the motor from overheating. If the hair dryer body is hot to the touch, allow it to cool for 10-15 minutes before continuing.

Ready to start working right away?

Consult our specialist on choosing a nozzle and mode for your task.