Contactor DILM 25-10 230V 50Hz EATON

Description Contactor DILM 25-10 230V 50Hz EATON

Series: DILM
Type: Contactor
Number of poles: 3
Nominal operating flow Ie (AC-3, 400V): 25 A
Nominal operating flow Ie (AC-1, ≤ 55°C): 45 A
Rated operating voltage Ue: 690 V AC
Nominal insulation voltage Ui: 690 V AC (based on IEC/EN 60947-4-1)
Nominal impulse voltage Uimp: 6000 V
Nominal short-hour vitriumvanium strum Icw (1 s): 350 A
Switched voltage AC-3 (230V): 7.5 kW
Switched voltage AC-3 (400V): 11 kW
Switched voltage AC-3 (690V): 15 kW
Drying category: AC-1, AC-3
Configuration of additional contacts: 1 NO
Nominal operating power Ie of auxiliary contacts (AC-15, 220V/230V/240V): 4 A
Nominal operating voltage Ie of auxiliary contacts (DC-13, 24V): 1 A
Nominal coil voltage Us: 230 V AC
Nominal frequency of the coil: 50 Hz
Coil application range (Us): 0.8 - 1.15 Us
Reduced coil tension (retraction): 65 VA (at 50 Hz)
Reduced tension of the cat (morning): 8 VA (at 50 Hz)
Mechanical wear resistance: 10 million cycles
Electrical wear resistance (AC-3): 1.5 million cycles
Protection level: IP20 (clem)
Operating temperature range: -25 °C to +60 °C
Temperature range: -40 °C to +80 °C
Liquid content: 10 - 95% RH (non-condensing)
Mounting type: DIN rail or screw
Width: 45 mm
Height: 75 mm
Glibina: 106 mm
Vaga: 0.44 kg
Cross-cut of head contact conductors (single-core): 1 x (1-10 mm²), 2 x (1-10 mm²)
Pererez head contact conductors (high-core with ferrule): 1 x (0.75-10 mm²), 2 x (0.75-6 mm²)
Head contact tightening torque: 3.2 Nm
Cross-section of conductors of auxiliary contacts/coil (single-core): 1 x (0.75-4 mm²), 2 x (0.75-2.5 mm²)
Cross-cut of conductors of auxiliary contacts/coil (high-core with ferrule): 1 x (0.75-2.5 mm²), 2 x (0.75-2.5 mm²)
Tightening torque of additional contacts/coils: 1.2 Nm