Add. contact DILM1000-XHI11-SI EATON

Description Add. contact DILM1000-XHI11-SI EATON

Type: DILM1000-XHI11-SI
Eaton part number: 199923
Number of normally open (NO) contacts: 1
Number of normally closed (NC) contacts: 1
Mounting type: Front
Nominal operating voltage of the exchanger (Ue AC): 690 V
Nominal operating voltage of constant current (Ue DC): 220 V
Nominal insulation voltage (Ui): 690 V
Nominal impulse voltage (Uimp): 6000 B
Washroom heat flow (Ith, at ≤ 55°C): 16 A
Nominal operating stage AC-15 (220-240 V): 6 A
Nominal operating stage AC-15 (380-415 V): 4 A
Nominal operating stage AC-15 (500 V): 2 A
Nominal operating stage AC-15 (690 V): 1 A
Nominal operating stage DC-13 (24 V, L/R ≤ 15 ms): 10 A
Nominal working stage DC-13 (60 V, L/R ≤ 15 ms): 6 A
Nominal operating power DC-13 (110 V, L/R ≤ 15 ms): 3 A
Nominal operating stage DC-13 (220 V, L/R ≤ 15 ms): 1 A
Recommendations for short-circuit protection (type gG/gL): 10 A
Nominal short-circuit current (Iq): 1 kA
Protection level: IP20
Operating temperature range: -25 to +60 °C
Temperature range: -40 to +80 °C
Mechanical Wear resistance: 10 million cycles
Electrical wear resistance AC-15: 0.5 million cycles
Electrical endurance DC-13 (60 V, 6 A): 0.5 million cycles
Conductor cross-section, single-core (1 conductor): 0.75 - 2.5 mm²
Conductor cross-section, single-core (2 conductors): 0.75 - 2.5 mm²
Conductor cross-section, rich-core with ferrule (1 conductor): 0.75 - 2.5 mm²
Conductor cross-section, high-conductor with ferrule (2 conductors): 0.75 - 1.5 mm²
Conductor cross-section, high-core without ferrule (1 conductor): 0.75 - 2.5 mm²
Conductor cross-section, high-core without ferrule (2 conductors): 0.75 - 2.5 mm²
Terminal tightening torque: 0.8 Nm
Gwent clamp: M3.5
Vaga: 0.03 kg
Compliance with standards: IEC/EN 60947-5-1
Compliance with standards: VDE 0660
Compliance with standards: UL 508
Compliance with standards: CSA C22.2 No. 14