Contactor DILM 25-10 (RDC24) EATON

Description Contactor DILM 25-10 (RDC24) EATON

Virobnik: EATON
Model: DILM 25-10 RDC24
Device type: Contactor
Number of head normally open contacts (NO): 3
Number of added auxiliary contacts (NO): 1
Number of added auxiliary contacts (NC): 0
Coil voltage: 24 V DC
Type of strumu coil: Constant (DC)
Coil type: Standard, with integrated dry diode
Nominal power supply AC-3 (400V): 25 A
Nominal strum AC-1 (690V): 45 A
Rated operating voltage Ue: up to 690 V AC
Nominal insulation voltage Ui: 690 V
Nominal impulse voltage Uimp: 6 kV
Nominal power of AC-3 engine (230V): 7.5 kW
Nominal power of AC-3 engine (400V): 11 kW
Nominal power of AC-3 engine (500V): 15 kW
Nominal power of AC-3 engine (690V): 15 kW
Drying category: AC-1, AC-3
Mechanical wear resistance: 10 million cycles
Electrical durability AC-3 (400V): 1.35 million cycles
Working hours (on): 17-27 ms
Working hours (off): 10-21 ms
Increased tension of the cat (retraction): 4.2 W
Increased tension of the cat (morning): 4.2 W
Operating temperature range: -25 °C to +60 °C
Saving temperature range: -40 °C to +80 °C
Protection level (clem): IP20
Connection type: Screw terminals
Max. head contact cable girder (single-core): 1 x 10 mm²
Max. head contact cable girder (high core): 1 x 10 mm²
Max. cable girder for head contacts (two single-core): 2 x 6 mm²
Max. cable girder for head contacts (two high-core): 2 x 6 mm²
Max. crossbar for auxiliary/core contact cable (single-core): 1 x 2.5 mm²
Max. cable crossover for auxiliary/core contacts (high core): 1 x 2.5 mm²
Max. cable crossover for auxiliary/core contacts (two single-core): 2 x 1.5 mm²
Max. cable crossover for auxiliary/core contacts (two high-core): 2 x 1.5 mm²
Installation: On a 35 mm DIN rail or with additional screws
Width: 45 mm
Height: 75 mm
Glibina: 106 mm
Vaga: 0.35 kg
Compliance with standards: IEC/EN 60947-4-1
Nominal short-circuit current Iq: 100 kA (at 400V, with gG 63A isolator)